Also,... don't go whaling on it. With repeated light blows you can see the chisel dig in to the edge. Be mindful that the only other thing holding up ...

Is it the same left muffler as at the Mundelein tech day? As I recall, nobody was interested in applying potentially destructive measures to it. This ...

A few things to be aware of: 1) The attachment to the frame on Original Equipment mufflers included a bracket that was like a bridge from the frame ...

Since it is not on your list, I would check the bolts that secure the driveshaft to the transmission output flange. Just loosen the ribbon clamp on th...

On every Airhead I have owned, the seat hinges from the right side. I have never seen one with a modification that hinges from the rear.

I used to own a 1988 R100RS. What I did with mine was to simply put it back together the way it was when I opened it up. If I remember correctly, ther...

I would be inclined to send the speedo to a specialty shop. There is probably an advertiser in the Airmail that specializes in this work. In my exper...

If the exhaust is in the way, you will have to remove it.

OEM grips are hard rubber. I never cared for foam grips because they seemed to induce a kind of numbness in my throttle hand. I have a set of grips ca...

Just do it. If you are super meticulous, measure the bores before and after the cerakote process. If the cylinders become de-formed, try again knowing...

If you loosen the axle nut, the wheel spins freely? This says to me that the bearing stack inside the hub is not shimmed correctly and/or the axle nu...

Richard's advice is spot-on correct. I would simply reinforce the notion that if the finned nut does not spin off easily by hand after using the corre...

Another thing you can do is to eliminate the chamfer of your socket by grinding the face of the open end flat. I bought an impact grade socket specifi...

There are 2 variations on the 5 speed transmissions. Before 1978, the shift lever is fitted directly to the transmission. The only adjustment availabl...

What kind of issue are you wishing to address? It doesn't cost anything to take them apart and clean all the contacts. If it is a functional deficienc...