Rocker arms, shafts, bushings/bearings. Rocker arm breakage. Valve gear. Pushrod tubes. Various parts of the cylinder heads

BREAKAGE OF ROCKER ARMS:

This is a rare occurrence, usually happens under racing conditions, with very high rpm, and/or high lift cams, increased valve spring strength, insufficient spring clearance at maximum lift, etc. However, it did happen, but rarely, on stock early Airheads, in non-racing use, and only in the /7 era, as far as I know. If you look closely at a rocker arm, immediately next to where the ADJUSTOR screws into the rocker arm, the web width there on the suspect rocker arms is about 7 mm wide. BMW made a production change and the rockers with the factory change had a 11 mm width. There was no change in the rocker part number. It does not appear to be a formal re-call by the Factory. I am not listing all the rocker part numbers, except two, because:
1. No new rockers are available that are 7 mm.
2. It is easy to confuse yourself over the SEVERAL part numbers used for the rockers. The original part numbers, long gone now, were 11-33-1-262-403 and -404.
3. You can measure your rockers.

You must be a member to view complete articles on this website. If you are already a member, you can log in here. If you aren't a member yet, you can purchase a membership here.
Scroll to top