Notifications
Clear all
Forum How To
5
Posts
2
Users
2
Reactions
1,196
Views
Topic starter
Finally overhauled my carbs but am having problems reinstalling them: inlet duct does not sit flush on the carb body. Have tried twisting etc to no avail. What's the secret? Properly installed, they are close to level but with the side closest to the cylinder head a bit lower? Be kind!
Posted : 06/12/2024 14:44
Topic starter
Replying to self. After looking at my photo, I realized that the airbox side sleeve was simply askew. Fixed. Carb side still not aligned, however. Any suggestions would be greatly appreciated.
Posted : 06/12/2024 15:02
@phil_y switch the black plastic elbows, each side is different
Posted : 06/12/2024 17:36
Phil Yasuhara reacted
@phil_y  Been there a few times myself until I noticed the difference.
Posted : 06/12/2024 18:50
Phil Yasuhara reacted
Advertisement
