@dale-aberegg be sure to let us know what you find. Can’t imagine what would be making it stick SO WELL. You couldn’t glue it together that good!

I copied this from Snowbum’s material, regarding unsticking a stuck clutch; I prefer to try the following things in order shown below; either method...

That is quite a conundrum. I wanted to rescind my suggestion of bumping it with the starter. Thinking about it, I got concerned about damaging the f...

Big question is why. Did you lube the splines when is was apart?

I should have prefaced my comments by saying - be sure the clutch is properly adjusted and actuating as it should FIRST.

Interesting. I don’t know about your ‘87, so I’m speaking from a ‘78. I would rock the bike for and aft and get it shifted into 5th. Pull the clutch,...

Those Bosch starters are mighty rugged. I finally decided to refresh mine in my ‘78 R100. It had never been out of the bike. I THOUGHT it worked fine....

@j-t-sutton Good to hear the opinion on Southland Clutch. I have had a couple phone conversations with them, and they seem very knowledgeable and “on ...

I just sent my compression ring, friction disk, and pressure plate to Southland Clutch for refurbishment. Trying this route instead of all new compone...

@j-t-sutton reading your original post, sounds like you have done everything correctly. I’m sure you have new driveshaft bolts as well. Happy riding! ...

‘78 R100 / Hannigan here. My long time favorite has been the very period appropriate Vetter tank bags - but they are hard to come by. The rear of the ...

@j-t-sutton yes, I believe you are correct. If you are reinstalling clutch parts you removed, you should mark them and return them to their original p...

I’m about to do the same with my ‘78 R100, so watching to see what advice you get. I did mine 25 years ago, and my memory isn’t what it once was! I ...

Any history on this? Since this or that was done, etc? I couldn’t watch your movie, unfortunately. Hard starting could be due to a myriad of causes...

@benjamin-greene If your lifters looked good, then I doubt your cam is shot. If you decide that you do need to look, you can also get a pretty good vi...