Yep, I tried every possible switch from every possible source, and came up empty. It was 2 to 5 days to order. The solution with the driveshaft fill ...

Probably not the issue, but Jeff C. reminded me of another occasion I had when my ‘78 had points. Can’t recall where I purchased the problematic point...

Hello Peter. I have been curious about your issue. Any determination? (Also feeling your frustration.)

The ADVrider forum … I recently was stuck with a very leaky oil pressure switch on my /7. Could not get a replacement where I was. I was “googling” in...

I live down in the RGV, in Mission. Agreed, there doesn’t seem to be any ABC activity in Texas. I think there might be a tech day once a year in the D...

No personal experience, but I’ve heard of iffy kill switches causing faults. They interrupt the 12v circuit to the coils - so kill the ignition. Th...

You may need to catch us up a bit. Did this occur prior to installing the new ignition, or since? I’m no expert, but in my simple thinking a mis-fire...

Oops - just occurred to me, your forks are newer / different than mine. So, not sure how your sliders drop off.

Reading your initial post, I see that you replaced the steering bearings. I just did mine, as well. Boy, they were shot. Anyway, so you had the fork t...

I’m feeling your frustration. Hope you get an answer from the wheel place. Reading your plight jogged my memory. Nearly an eternity ago, I had a si...

Any progress on this issue? I’ve been reading with curiosity… what could it be?

(Worthless, irrelevant comment). Sometimes it just strikes me as funny. Us guys with these old bikes. When we put things together, we either use “Anti...

I’m presuming since you verified that the needles were in the correct position, that it was also verified that both needle jets are 2.68’s. Also impor...

I agree, the slide needles and needle jets should last many miles, and it is unlikely that one side would wear differently. Myself, if it were a “new ...

Hello Scott, if you get back into your carbs, and you didn’t last time, I would replace the slide needles and needle jets. It looks like (on that Bing...