FORUM

Len Lambert
Len Lambert
@cptnwightwen
Eminent Member
Joined: 08/24/2020 19:59
Last seen: 08/19/2024 20:37
Topics: 6 / Replies: 18
Topic
Forum
Replies: 1
Views: 3897
Topic
Forum
Replies: 0
Views: 1532
Reply
Windshield selection for crosswinds

What brand is your deflector?

8 years ago
Reply
Motor oil beneath my bean can

Thanks for putting my imagination at rest.

9 years ago
Reply
Motor oil beneath my bean can

Thanks Wobbly. I checked the fiche on MaxBMW and no seal for the camshaft is shown. Just for the heck of it I checked other engine models and sure e...

9 years ago
Topic
Replies: 4
Views: 5393
Reply
Runs bad and idle increases to over 4000 at a stop

I live in Alaska and the bike is stored from October till late April at the earliest. I've taken your advice and emptied the tank, the carb is empty ...

10 years ago
Reply
Runs bad and idle increases to over 4000 at a stop

Thanks Wobbly, I truly appreciate your guidance. I've owned the bike for less than a year and a half. While the PO claims regular maintenance, I've ...

10 years ago
Reply
Runs bad and idle increases to over 4000 at a stop

I decided rebuild the carburetors, replacing all the rubber parts and brass parts. The carbs were dirty and needed the cleaning. The main jet area i...

10 years ago
Reply
Runs bad and idle increases to over 4000 at a stop

Thank you Wobbly. I really appreciate your suggestions.

10 years ago
Topic
Reply
Electrical problem

This is what I found. After fully charging and reinstalling the battery, the 12 volt reading in that cable disappeared which puzzled me for a while. ...

10 years ago
Reply
Electrical problem

Actually the cable in question is a perfect fit on the lower bolt holding the Ignition Control Unit. I unwrapped some of the cable and sure enough th...

10 years ago
Reply
Electrical problem

The 12 volts read on the multi-meter whether the ignition is on or off. I am using the motor block as the ground. I will peel back the black wrappin...

10 years ago
Reply
Electrical problem

Thanks Wobbly. I put a multi-meter between the wire and ground and it reads 12 volts. Since I bolted it to ground, that is what caused my short. Th...

10 years ago
Page 1 / 2

Advertisement

Scroll to top