Here's how the circuit works... Power enters the flasher unit and comes out as pulsing power. This "pulsing power" then goes to the turn signal switch...

It's absolutely no problem, and you're very welcome. I could tell that you were one fact away from fully understanding, which was leading to a lot ...

Good questions. Basically ALL 40 year old master cylinders (m/c) need some attention ! The reason is that DOT4 brake fluid attracts water, which cause...

I have had to do extensive electrical circuit tracing and repairs on my 1979 R100 /7 and have not found any faults (so far) in the Haynes manual schem...

I'm trying to determine if one setup delivers better overall performance than the others. For the best performance, also make sure the intake ai...

Well I think I’m just going to give up I don’t think I really get any benefit from adding this particular aftermarket thermostat/ cooler except for ma...

I have a nice, spare, cowl-mounted luggage rack, but it doesn't have a back rest incorporated into it. And it's for the early metal seat cowl. How...

Looks like the Cyron LED H4 replacement I've been running. It's like 3000 lumens or something. It's brighter and draws ~20W less than the stock 65W bu...

Unless I'm missing something, I believe that question was already answered. I'm obviously not as good looking or as experienced as Scot, but we do...

Goose - You might look at the oil lines from Motoren Israel. Here....

I'm obviously not as good looking or as experienced as Scot, but we do use very similar brake hose modifications. I believe your answer is going to be...

I have a line on a 75 R90/6 that is mostly together. I can get it rather cheap and as long I sort out he electrical, Stan in Gainesville is game to a...

You have most probably only made a common apprentice error. Place the bike on the centerstand and chock the stand as required to get the rear wheel...

As with any gasket job, 99% of "leakproofing" is in the surface prep and not the gasket itself. I run a stone around both mating surfaces to remove an...