Scott is correct. Typically, EI initial installation settings are just that: Initial Settings. The ignition timing is NOT set; it is only close en...

And tell us... • Is this bike stored on the side stand, leaning left ? • When was the last valve adjustment ? You know Airhead valves tend to...

That's exactly it ! But instead of getting close and having to insert a cotter pin, you can get right on the money. You'll actually end up with a slig...

I've done this twice, once each to a /6 and a /7. Both times I did as you did, and simply removed the front wheel and fork crown. The forks dropped ~8...

"Folklore" was indeed a poor choice of words. "Standard Feature" might be closer. 🙂

This "lower than normal" oil level is a continuing mystery that has reached the level of BMW folk lore. Whatever the reason, my '79 RT displays the sa...

Might help some to know what model you're asking about. /2, /5, what ??

My concern was that if you stuck in a plug that was too long, or an adapter that was too long, that you'd potentially damage the piston. Is that not t...

The adapter should have a fat o-ring to make the seal at the spark plug gasket surface. So the length of thread engagement is meaningless. Therefore, ...

From my research there are 2 breather systems, a phenolic disc and the metal reed valve. A 1982 bike should have the later (better) reed valve system....

Many thanks, my friend.

14mm short reach will work fine. Be sure and hold the throttle wide open while you kick until the gauge stops climbing. Both cylinders need to be ...

I got back to looking at my carburetors. Apparently, the former owner ran rubber tubing between the two vacuum ports. I'm guessing he lost the screws....