I think WD40 would be a good as it is a water displacement which is a good idea for the old style ignition switch as they are not a lock but contacts...

My understanding for what you see is it makes the lifers rotate.

Thank for the reply. What I found was the battery cable passes in front of the solenoid connectors solder joint. The front has a sharp point and the c...

Hi, After reading your symptoms it seems like it may be losing one cylinder. What I would try is to ride until the problem comes up hopefully close to...

Good to know. I've used Terry "Wirespokes" (Adventure Rider) in Oregon. He does excellent work.

First what is intermittent? Does it stumble at speed or under acceleration? I've never in over 35 years had a stator go bad but a few rotors although ...

This site has a great series of "how to" on the Bing 64 carbs. There are 3 parts to it so scroll down to see them all.

No, a flashlight will help but if a bolt came out it should be very noticeable.

You can see the clutch bolts through the timing hole.

If you were stopped at a light in gear with the clutch pulled in then the transmission gears are not moving at all and the noise is coming from the c...

If you had the clutch out while it is running in neutral the input shaft is spinning in the trans.

I have a 150 psi VDO gauge and sending unit. You have to put in an angle adapter for the sending unit. It will run the light and gauge. My bike is a ...

My funniest "crash" was leaving a parking lot that was very wet and oily. My 66 R69S conversion went out from under me and KEPT GOING! I had to chase ...