hi If you have not got bing manual, you might like to get it, lots of info, I started using colour tune kit you get to see colour of spark makes setti...

hi After many years I have used a gauge That uses mercury, I have had it for twenty plus years. I also use a colour tune kit to set idle mixture. You ...

hi Lots of great info here, I have wedgetail system from Australia, ease to fit and build quality exceptional best wishes

hi I agree with everything Richard says I went on stage further and rebuilt whole wiring harness. I wrote an article for Airheads magazine check yo...

I did not go that route, the wire between the diode board and the starter motor is the weak link replaced it with 6 ga wire and hi out put regulator n...

totally agree preserving sounds better

Hi I had this problem and things I went though cured the problem check connectors on coils these were loose Check you have not crimped the wi...

hi mike I rebuilt my loom my self, Although I have r100gs same sort of thing, I replaced the wire from B+ from diode board to starter motor with A...

Have you check stator continuity, this is a regular failure

HI I had enduralast system got me to Alaska and back then quit. Switched back to bean can, finally got a wedge tail system all good, build quality is ...

Buy a Clymer maintenance manual ,spend a bit of time reading ,then start to work at it slowly enjoy the experience

new airmail, congratulations a breath of fresh air. Looks professional and nicely done, look forward to more like this. Tough decisions over the las...

HI I drilled my solder points on brushes out, then soldered new ones in, then check alternator light, check stator , final project the wire between t...