Many thanks, my friend.

14mm short reach will work fine. Be sure and hold the throttle wide open while you kick until the gauge stops climbing. Both cylinders need to be ...

I got back to looking at my carburetors. Apparently, the former owner ran rubber tubing between the two vacuum ports. I'm guessing he lost the screws....

I'd like to know myself. Sometimes my crystal ball goes on the blink.

Well, that should certainly fix it !! Good luck, my friend.

► I would not rebuild the carbs, but rather remove the float bowls and inspect for crud. If no crud is found, then put fuel in the tank, turn ON the p...

► I ask because there are several typical scenarios at play here. You may not need high dollar parts at all... • Someone may have forgotten to disc...

In your photo it's on the far left. On the underside of the carb, located on the port going into the cylinder head are 2 cylindrical bosses. One tall ...

I sure would like to know more about these "highway lights".... • What is their wattage and how many of them are there ? • Is everything fine if the...

► Play in the throttle cables lets the throttle valves seek their own setting. If the throttle cables have no free play, the idle speed adjust screw w...

• Amazon has No-Ox for $13 in a container large enough to protect every vehicle you own. Smaller tubes are available. • Corrosion wouldn't single o...

I need to find a DIY on replacing the diaphragms. I really appreciate everyone's help. This is a great forum. That's easy. About 10 minutes per si...

If the fuel line is splitting due to age OR ethanol, then the carb diaphragms and the intake hoses also deserve a thorough inspection. I don't thi...