I've seen this attempted before on an R80RT, and the guy gave up leaving a mess of the bike. Having removed an RT fairing and changed it over to a...

This is wonderful! A 200 mile test ride proved the switch was the source of 98% of all my oil issues. The entire motor exterior stayed oil-free and wh...

A common misconception. The bore doesn't need to be in pristine condition to work just fine. If you'll make some measurements you'll find that the pit...

This R75 is a joy to ride. It does not compare to my Harley Road King and it's not supposed to! The RK does everything better... Well, maybe ev...

The typical failure of these master cylinders is from "not working great" or "failure to bleed properly" rather than outright leakage. If your rebuild...

Thanks !!

Thanks. Mine seems to be dripping oil out where the spade connector exits the plastic body. Some stories online talk about the plastic end blowing off...

Classic oval pattern too. 😛

It's my humble opinion that from a pure manufacturing standpoint that the flywheel and crank are balanced together. That is, that weight is removed fr...

Acewell, Koso, and Trail Tech are the familiar ones.

I know the Master cylinder works best at the highest point, but I've always liked the cleaner look of no hoses. That's not why I suggested handle...

Then you might also wish to investigate a master cylinder with a smaller diameter bore. Something around 13mm. You'd want that handlebar mounted too. ...

PS. I'm in need of a single disk to replace my deeply scored rear disc. If this upgrade leaves you with a good spare, I'd be interested to hear a pric...