I installed a new Odyssey PC925 a couple of years ago. It's larger than the PC680 (the holddown j-bolts are just barely long enough). Since the PC680 ...

It's fairly simple, and I think I can describe it..... • Green/Black is 12V power (from the fuse). The Green/Black wire to the handlebar switch con...

Balancing the carbs is always a good thing. Especially if it's been 5K miles or more since last done. When you're doing that, be sure and twist the id...

Turns out you may have been spot on with the vent bolt not venting, causing the leak. One would hope that a high level of pressure would be able t...

2 things can cause that.... • Air leak at the cross-over tube. There is plenty of un-burned fuel inside the exhaust. On decel, air gets sucked in t...

Since your bike has tubeless rims, get a tire plugging kit and toss that in as well. I also take along an extra length of fuel hose although you can b...

Jerry - Sounds like you have a big adventure planned. Wish I was going with you. One of the leaders within our local group has cancer and was plannin...

Do you think it's ok.... • Do I think that's the highest octane available to you ? No. • Do I think your engines will sustain permanent damage ? No....

I have replaced hundreds of fork seals, but never on a BMW. If I understand your question correctly, you are asking about the reason for the void unde...

Thank you. The red o-ring is white, the red is gasket sealer applied. Ah, thanks for the correction. My bad eye sight. Your existing oil filter w...

• There are several excellent brands available, but EBC seems to be the leader in the motorcycle market. • If you have dual front discs, then you'...

Those type "speakers" are usually representatives of a specific product's Marketing Dept. As such you're not going to get as un-biased assessment as y...

• That nick is nothing to worry about • Did you moisten the lip of the seal before installation ? Put some grease on the shaft maybe ? • It's go...

It would need to be more than a "nick" to leak like what you're describing. More like a gouge. No, I'm fairly certain that your oil seal was not cente...

As I understand your issues from the photo above, you seem to have a superfluity... Looks like the PO broke the aluminum oil filter cover, so he ba...