I'm not familiar with the headlamp, but I can tell you that almost all the better replacement bulbs are for the bulb sockets known as H2, H4, etc. ...

Welcome Aboard !!

1) Your starter needs disassembling and cleaning. Being sure to re-pack the bearings with new grease or replace them. The bendix throw parts are proba...

Glad it wasn't serious. SuperBrightLEDs sells those BA7 bulbs in a Red LED that you can see in broad daylight. You might want to try some of those....

1) I would immediately check the condition and position of the oil filter. 2) In the rear of the filter well, is the oil filter by-pass valve. Thos...

So you got a 4x 11mm pin.

• Most bike sales are in May and June. • Most bike sales are now used bikes, but most bikes being sold are in the price slump. If you'll check a so...

Welcome Aboard !! Quite a few of us are dealing with that dilemma. "RS" used to stand for Road Sport. Now it stands for Rider in his Seventies !! ...

I'm not an expert on the BMW engine, but typically pins in the crank area usually cannot "fall out" without the crankshaft first being removed. Me...

As with the engine oil pressure switch... BMW did not use a special switch. Measure the threads very carefully, then go to one of the older auto parts...

The mounting racks are rather universal for all Airheads with dual rear shocks. You might want to find a rack online and mount that at home. Then ...

• The front brake lamp switch is in the hydraulic line, under the fuel tank. Remove the fuel tank and you'll find it. • Your issue could have 2 roo...

So to answer some of your other questions: * I'm using fresh 91 octane gas. * I have the original blue Rider's Manual from BMW. It states about f...

There are literally hundreds of brake line makers using the PTFE ("Teflon") internal hose surrounded by stainless steel braid, with or without an exte...