I pulled one of the carbs off to take a look. It needed some serious cleaning on the back and looking at the slide it's obvious they need a rebuild. J...

I like the ABC to be all about airheads. I think it makes sense to keep it as owning airheads but as a lot of members age out we will be losing more m...

Anyone have any preferences for tires for an R100?

Next up bleeding brakes. Been awhile since I've done this on anything so it should be fun.

I did the JB Weld fix and I think it is totally bomber! I'm not worried about a little paint.

The JB Weld fix looks like it worked very well. I added a 2nd coat for a little extra reinforcement. I remember reading in plenty of places to chec...

Ok great, that is good info. I haven't dug very far into the windscreen yet. I was using SP1 to shine up the bike and it brought the windscreen back t...

Thank you for the insight Richard. The piece that is cracked out is one of the bolt inserts-no surprise. Upon inspection it had been fixed before but ...

Anyone have any good ideas for a fix to this little crack in the fairing? I hear it's ABS so would need a proper glue.

It's in the shed, going to get it registered today.

It arrives tomorrow.  69904934360__E28D3B8A-18FB-48BE-8E7C-XL.jpg

$142 in CDN is pretty expensive.

On eBay they were going for $100, there were a couple available when I checked. I was just reminded there's a used bike part place here, I'll go check...

Anyone know where I might find a replacement gas cap? I talked to BOb's and they say BMW doesn't make the original anymore so used may be the only opt...

I went to see it yesterday and a few little taps on the float bowls solved the fuel leak. It pretty much fired right up and sounded good. I got to rid...