FORUM

David Elkow
David Elkow
@4949
Reputable Member
Joined: 08/24/2020 18:19
Last seen: 04/15/2024 17:53
Topics: 11 / Replies: 278
Reply
RE: New Member intro #18533

@16813 ok, I’m curious, what is “the cat”?

2 months ago
Reply
RE: 2024 List

@edward-silverman hello Edward. I’d start a new forum topic with your question. Folks may not see it here.

2 months ago
Reply
RE: 2024 List

I’m planning on attending the “Hill Country Hangout” in Kerrville, TX (just NW of San Antonio) on April 19 & 20. It’s an MOA sanctioned rally put ...

2 months ago
Reply
RE: Ride your airhead!

@16813 hello, Mike

2 months ago
Reply
RE: Ride your airhead!

I’m 68 these days. The airhead I ride I bought when I was 25. I don’t think I could part with it. We have covered a lot of miles together, and venture...

2 months ago
Reply
RE: 1978 R100rs Fly Wheel Bolt Torque Spec

This thread by Eric is titled “1978 R100RS … “

3 months ago
Forum
Reply
RE: 1978 R100rs Fly Wheel Bolt Torque Spec

‘78 RS also. My BMW service manual says 72 - 76 ftlb.

3 months ago
Forum
Reply
RE: Super tight top fort retaining nut

Crazy good job on the “jig”. I’m gonna use that design, if you don’t mind! A tool I’ve found handy for fork tops and bottoms is a wrench like this (...

3 months ago
Forum
Reply
RE: Throttle Lock (Or Cruise Control) ?

I bought the EZ return springs. Had them on for a while, then went back to standard springs. Maybe I didn’t give myself enough time to adjust, but, wi...

3 months ago
Reply
RE: H4 LED replacement plug'n'play sought

I’ve been using the Cyclops LED for several years. I, also, do not ride at night typically. The few times I have, I’ve thought the light was quite go...

3 months ago
Reply
RE: Roll-on / roll-off bucking

Very good. Good to find a competent person you can trust for help. That’s quite a list. My ‘78 came out of semi-retirement about 5 years ago, when I ...

3 months ago
Reply
RE: New Guy in Eastern North Carolina

Welcome, Matthew! Dave from south Texas.

3 months ago
Reply
RE: Roll-on / roll-off bucking

I am a nerd when it comes to analyzing things. On the final drive spline there are 28 teeth. There are a corresponding 28 teeth on the wheel spline. ...

3 months ago
Reply
RE: Siebenrock Power Kit for my 1971 R75/5 - Cylinder base sealing

I apologize. I re-read your post and realized that when you cranked the engine to test oil flow to the rockers, the same oil also flowed out at the cy...

3 months ago
Forum
Reply
RE: Siebenrock Power Kit for my 1971 R75/5 - Cylinder base sealing

P.S. - Very nice looking /5! And, what are those two electronic? devices (dark grey boxes with green dials) on the counter behind the bike?

3 months ago
Forum
Page 2 / 20

Advertisement

Scroll to top