FORUM

Lawrence Ayotte
Lawrence Ayotte
@8244
Eminent Member
Joined: 12/26/2015 17:45
Topics: 8 / Replies: 41
Reply
Snowflake straightening

I thought I would wait to see what kind of job they do before I shared it. I’m told that they straighten wheels for the race crowd at Loudon.

6 years ago
Reply
Snowflake straightening

Found someone, thanks anyhow.

6 years ago
Topic
Replies: 7
Views: 6436
Topic
Replies: 1
Views: 3231
Reply
Windshield selection for crosswinds

Laminar Lip should take care of that problem. www.laminarlip.com/

6 years ago
Reply
How to remove left side cover on 1983 R80 RT ?

The cover will go on and off without removing the handle. AS my mother used to say "You just have to hold your mouth right".

7 years ago
Reply
Carburetor and ignition switch issues?

I'm confused about what the symptom really is. It sounds like you are describing the engine actually starting as turning over, not the action of the s...

7 years ago
Reply
1.5 amp current leak

Using an ohm meter isn't the way to go for checking for a wiring problem. Ohm checking an unloaded circuit is going to trip you up, for sure. Checking...

7 years ago
Forum
Reply
Tire recommendations

Oh no, another tire thread! Tire choice is a very opinionated subject. In my case, after decades of riding with many different brands over hundreds...

7 years ago
Forum
Reply
New Guy

So, another Mainer! Maybe we will run into each other this season (Owls Head maybe). Welcome aboard. Mark

7 years ago
Reply
1981 R80G/S

61 13 1 244 038 back ordered at Max with no release date.

7 years ago
Reply
bar end turn signals

I have bar ends on my R65. I installed LED replacement units in place of the incandescents and used an electronic flasher to get the flash rate right....

7 years ago
Forum
Reply
Replacing stock '95 GS, 32 mm Bing carbs with 40mm?

I'm thinking you will find even more issues with that swap, as there is more to the 40mm system than just the carbs. If my bike had the same problem, ...

7 years ago
Forum
Reply
Clutchless shifting

I have heard that puttering around at too low rpm accelerates spline wear. Any insights?

7 years ago
Forum
Reply
gen light not coming on, not the bulb

The OP's problem solved on the first page and then two more pages of wiring harness maintenance. I think we all need to go for a ride! It does occur t...

7 years ago
Page 2 / 4

Advertisement

Scroll to top