FORUM

Richard W
Richard W
@wobbly
Member
Joined: 03/05/2016 17:59
Last seen: 07/17/2025 03:22
Topics: 91 / Replies: 2568
Reply
Did I fry my Diode Board?

Welcome Aboard ! Yes, removing one of the battery leads is a must when the front engine cover comes off. • Your actions would not normally cause...

6 years ago
Reply
1982 R65 Timing Issue

And did you install new plugs ? Look, plug wires, caps and new plugs all together total under $20. Why don't you stop all this foolishness and simp...

6 years ago
Reply
1982 R100RS - Value?

That's a very hard question to answer. So what I would do is go to the top of the forum, to the pull-down menu "AirBazaar". There you will find severa...

6 years ago
Reply
75/5 carburetors exchange

It takes me the better part of a whole day to go thru a set of carburetors. You would have starved to death as a pro-mechanic. 👿 The se...

6 years ago
Reply
75/5 carburetors exchange

I would say that it will take you as long to fashion the new choke hookup as it will to rebuild the older carbs. Of course that's assuming you have a...

6 years ago
Reply
R75/5 Gearbox Rear Cover

I believe that drilled hole is the breather for the drive shaft oil. The drive shaft and the gearbox then breathe through the speedo cable retention b...

6 years ago
Reply
electrical issue

Bill - Why don't we start with some basic info, like a model year. The parking light and tail light circuit are killing my turn signals. I can't f...

6 years ago
Forum
Reply
1983 R80RT Flywheel replacement

What is the need to replace the brake fluid? Bike was serviced and inspected and ready to ride for the season before all this. 1. Allow me to reve...

6 years ago
Forum
Reply
1982 R65 Timing Issue

Your bike isn't "pinging" at all. It's actually trying its best to run on the left cylinder. In fact it does run quite a bit. That can be plainly hear...

6 years ago
Reply
1983 R80RT Flywheel replacement

Yes that is correct. The RED wire is bringing power from the charging system. The heavy cable carries it the balance of the distance back to the batte...

6 years ago
Forum
Reply
1983 R80RT Flywheel replacement

Well, "poop happens" ! Your damage is rather minimal and all internal. Most other brands this age have slung a rod or cracked a piston and although...

6 years ago
Forum
Reply
1977 R100/7 overhaul

Welcome Aboard ! • The first order of business is to figure out why the heads were removed to begin with. These older heads will need service at ~1...

6 years ago
Reply
wrenching or parts ?

Jim is correct. My idea is that the L/R marking are only so that you can use the same valve cover gaskets over and over if you re-fit the covers in th...

6 years ago
Reply
1983 R80RT Flywheel replacement

This is important! When you get to the place where you want to remove the flywheel, you must block the crank from moving forward. If the bolts al...

6 years ago
Forum
Reply
'88 r100rt Electrical Problems (New owner)

Any tips on jetting/tuning if I switch to pod filters? Please explain why in heavens you's want to consider this. It can't be for performance, bec...

6 years ago
Page 104 / 178

Advertisement

Scroll to top