More photos... Now here's an especially good photo because fully 1/2 of the bike is disassembled and missing, but the bike is still rock solid on t...

$250 seems to be the minimum charge for this work. Believe me, you got a deal. But, glad to hear you're back on the road again !

You'll need to consult your workshop manual for details. Sorry, I'm not near my books at present, but the important bit is this.... The cylinder head ...

Start a new thread and we can discuss this. PEACE.

Many thanks, Jim. I have not had time to clean the bike, but the oil has been replenished and the loss was about 40cc. Not great, but on the other ...

That was a very hard thing for me to accept, but Jim is correct. Amazingly, rocker covers require no sealant. I can only add the rather obvious add...

Chris - There is the LAW and there is ETIQUETTE. In a free society the Law allows each of us many rights and privileges. Etiquette demands that ea...

Wobbly. Thank you for the info. I’ll check the forum for other posts. But my concern is about the heat generated and how to get rid of it. Eric...

The speedometer and odometer are 2 distinctly different instrument parts. The speedometer needle "wandering" can be cured with a fresh application of ...

Thanks Wobbly! Very good suggestion to epoxy the plug in. I may go that route for now. Hank - You might get used to this oil sucking idea and n...

This subject has been covered on multiple times on this forum, but here's a quick synopsis.... • All H4 replacement LED headlamp bulbs (that I have...

On any repair that involves tapping new threads into the case (oversize thread, Helicoil, weld and re-tap), the answer to your question will be determ...

The Engine Control Unit (ECU) is mounted on an aluminum heat sink, and the heat conductive paste between the two can dry out and allow the ECU to over...