FORUM

Brad Wernecke
Brad Wernecke
@14295
Active Member
Joined: 08/24/2020 19:28
Last seen: 09/14/2024 12:03
Topics: 0 / Replies: 10
Reply
RE: Question on initial steering head bearing install

Thanks Dave, you hit the nail on the head! Thanks for simplifying this. It is the same set up for both bikes, and your procedure apply to both model...

10 months ago
Reply
RE: Question on initial steering head bearing install

Richard and Mark, Please note: Mark has a 1988 R100RS which is a newer mono-lever model. His bike will have very different parts and specs than tho...

10 months ago
Reply
RE: Question on initial steering head bearing install

Mark I can not figure out how to contact you! So come and meet other WI airheads for a beer on Saturday, December 2 around noon, at the Great Dane Br...

10 months ago
Reply
RE: This is a test.

Jim testing this as per our conversation.

1 year ago
Reply
RE: Valve noise after adjustment...again

We had this at a tech-day once! After much sleuthing we found one adjuster screw thread was buggered from previous adjustments. Even though we had v...

1 year ago
Forum
Reply
RE: Help Identifying Cycleworks(?) Tool

Crankshaft guide ring removal. Thank Brook Reams for all you need to know about it, part way down the page here: /p>

2 years ago
Forum
Reply
RE: Speedometer cable retaining/battery ground bolt on the gearbox nearing being stripped

Many ways to skin a cat and all the above suggestions are great for all airheads. But Yippy Ki-A…you’ve got a 1978 R80/7! On your model you should f...

2 years ago
Reply
1978 R80/7 engine suddenly quits running at speed.

I’ve got the same year/model, not an uncommon problem for us! All great advice from Wobbly. Quote: “Power for the ignition typically starts at t...

6 years ago
Reply
Badly done fuel tank recoat

Thanks! I can now see whats in your photo's and why! I think for the acid wash step I will stick with just the plug, washers and bolt/nut, then te...

8 years ago
Reply
Badly done fuel tank recoat

Good Info! 1559 could you elaborate on the plugs you used? Anyone else, how have you gone about sealing the large tank filler hole when its a l...

8 years ago

Advertisement

Scroll to top