Last seen: 04/19/2024 13:19
Here's a picture of the drain plug, just fyi IMG_2638.jpeg
Thanks. I drove about 5 or 6 miles yesterday and no leaks so it may be OK. But I'll keep this in mind if I have any leak issues.
Ok, everything went fine. The depth of the canister is within spec per the articles I read, no the previous oil change used the same single shim and ...
If the oil bypass valve is bad, can that be replaced from inside the oil canister, or is it a major engine task?
Thanks guys! I'll work on it today and see how it's currently configured. I did some reading (thanks to Brad) and it makes more sense now.
Got the bike all back together, up and running, did some riding and it all works as it should. 🙂
Thanks for the info. One question - you mention the bearing nut having a torque spec. I’m wondering since it is designed to be tightened using the “...
Hi, Brad! I'm trying to figure out how to reach you, but also can't seem to figure out how to contact you. I'll try to be at the December 2'nd event...
I'm going to do something like this, but under the cover. Like an "H" using 2 T connectors. Where is a good place to get these T's to be sure I have...
Quick update - With the air intake box's top and the filter removed I was able to get in to the back of the cover and pull the hoses off the solenoid ...
Thanks for the post, Richard, and for the diagram. If it comes to that, I can certainly go that route. Steven, thanks. I'll look that up. I have t...