After I bought the fairing harness for my RS from BMW Max, Rick Jones at Motorrad Eliktrik told me he could also get those significantly cheaper, he s...

Congratulations on an exciting find ! • That's an extremely fair price, especially considering the low mileage. • These bikes age very well. Just ...

The pins within the multi-colored connection block simply connect color to color. So if your new harness uses wire colors close to the original, then ...

My bad. Mr. 14295 is very correct. Leakage of any brake fluid over the last 40 years can and will cause electrical issues, but most especially with...

The engine is not rebuilt, so braking in the engine is not needed. Mr Lemon - Read again. I did not say your engine had been rebuilt. I said in it...

Hey, welcome aboard !! In my experience, it should be fine. It's low, but that's to be expected in it's present (unstarted) condition. Once the...

The rear brake pedal and the actuating rod adjustment take ALL the piston return spring pressure once the m/c is installed in the bike. IMHO, the was...

I have seen people use the yellow 3M Weather Strip Cement, also known in the industry as "gorilla snot". This will adhere rubber in place, but it can...

I'd try pressing the washer into place with a "deepwell" socket squeezed in a bench vice. I don't think this fit is as tight as normal pressed-togethe...

Intermittent issues like this are the hardest to find because they leave no trace after the fact. There are many suspects within the fuel and elect...

Blake - You are correct, some time this winter you need to disconnect the battery (to prevent shorting out the diode board), remove the engine's fron...

I take a slightly different approach. I'm not saying it's better, just different.... ► Jim and I agree, it is the kiss of death to leave ethanol fu...

Never seen what you describe, but while investigating other gas cap trivia, it was discovered that a lot of the screw-on (VW and Audi) and twist-on (T...

Link... He's opened his clock to replace the two 100 micro farad capacitors. He gingerly pries the aluminum bezel open by going slowly around the r...

► Instructions for removing the SHED system: Fuel "starvation" could have several different causes... 1. Fuel not getting to the carbs Have yo...