I'd like to put a set of stainless pipes on my 1988 RS, but I can't get anyone to answer the phone. I must have called EPCO a dozen times over the las...

On my R80RT the turn signal indicator does not light when the four way flashers are on only the light in the switch lights (Is this correct?). ...

I'm no expert, but I'm willing to take a stab.... This could be several things, depending on the full description of the issue. ► If the Hi Beam i...

► Right in that same location, on the coil mounting bolts, is a bundle of BRN wires being secured with one of the LH coil mounting bolts. That bolt is...

As a wild ass guess, I would assume that the only thing in a headlight bucket that might make a buzzing sound would be a relay. That would be my...

Hey, that's great news ! Congrats. • You're correct, there is an empty male spade connector on the rear of the ignition switch. That's a great pla...

It's been 40 years since I installed my last Vetter, but as I remember only the headlamp wiring is extended. None of the other stock wiring is altered...

It's as Jagarra said. • Use a lighted test lamp/probe connected to an engine fin. Follow the power from the battery Positive, to the starter, to th...

Snowbum details converting the lamp sockets to take dual filament 1157 bulbs on his web site. I made the conversion following his directions and found...

There are fuses to check first. These are the white German tubular type used in VWs that are about 1/2" long. They live on the multicolor circuit boar...

This may seem like a stupid question, but are you in Maine ??

Clutch slippage? Ordinarily clutch slip is easy to identify at low speeds or hard accel. If the clutch is able to handle the load up to 50 mph it will...

Scott is right. You need to get out and just ride that thing. Get some maps out and find a small town or scenic attraction 100 miles away. Plot a cour...