I know little about the circuit board itself. I imagine it is similar to other printed circuit boards that can sometimes be damaged from over heating....

Hi and welcome. I'm far from a /6 expert, but I will try to help. • Power is delivered via Red wires (plural becasue it is multiple wires and conn...

Just to close the loop, my New Year's Day project was to disassemble and inspect the starter relay and voltage regulator, both of which appeared to be...

Thank you VERY much for sharing. From their appearance (very oxidized silver) both my regulator and relay appear to be OEM, but untouched by brake flu...

Oil in the galleries going to the valve gear probably did back-flow to the sump during the storage and work periods. All liquids seek their own level....

Believe I have what you describe as a mini-cube starter relay w/silver cube about an inch square underneath master cylinder. Care to expound? "Mini...

... but my question now; is it possible to lose prime at the oil pump? Rodney - Certainly no expert on the subject, but I suspect there is nothin...

Gremlins can indeed be hard to find. Some suggestions... • Be prepared with extra fuses and a test lamp, should the worst happen out on the road. P...

I never had this much trouble with my Kawasaki Concourse. Help ! This is becasue the Concourse probably is fitted with electronic fuel injection, w...

Wobbly, that looks like the lift I've seen. But, I didn't know it had a back door wheel drop out. Most of the "flat work area" type lifts do have t...

I should add that picture was taken before I put the 30 to 45 degree cross hatch pattern to the bore. Thanks for adding that. I was looking at the ...

Can't comment on the bags themselves, but there is generally no reason to worry about "power issues" since blinkers are an intermittent load on the el...

Batteries Plus is an excellent source for 3rd party batteries and reliable battery information. It is also important for the battery to fit snugly int...

Thanks for your help. I attached a picture of the rust in my first post. Mark - My bad on the photo. Apologies. However, it would be better to ha...