FORUM

David Elkow
David Elkow
@4949
Reputable Member
Joined: 08/24/2020 18:19
Last seen: 06/22/2025 03:58
Topics: 13 / Replies: 340
Reply
RE: New Guy in Eastern North Carolina

Welcome, Matthew! Dave from south Texas.

1 year ago
Reply
RE: Roll-on / roll-off bucking

I am a nerd when it comes to analyzing things. On the final drive spline there are 28 teeth. There are a corresponding 28 teeth on the wheel spline. ...

1 year ago
Reply
RE: Siebenrock Power Kit for my 1971 R75/5 - Cylinder base sealing

I apologize. I re-read your post and realized that when you cranked the engine to test oil flow to the rockers, the same oil also flowed out at the cy...

2 years ago
Forum
Reply
RE: Siebenrock Power Kit for my 1971 R75/5 - Cylinder base sealing

P.S. - Very nice looking /5! And, what are those two electronic? devices (dark grey boxes with green dials) on the counter behind the bike?

2 years ago
Forum
Reply
RE: Siebenrock Power Kit for my 1971 R75/5 - Cylinder base sealing

I hope you found an answer to your question. When I read your description of the situation, even though I do not know the answer, I did have a concern...

2 years ago
Forum
Reply
RE: Best of the holidays to you all!

Hello Mike, and Holiday cheers to you and your family! Have a warm and safe winter up there!

2 years ago
Reply
RE: Oil Gallery Blind Plugs - removal

One more picture (only one I took!) - the rear facing plug on its way out. Removal of this one was easy-peasy.  IMG_0513.jpeg

2 years ago
Forum
Reply
RE: Oil Gallery Blind Plugs - removal

Follow-up on my own post. I did successfully replace the two oil gallery “blind plugs”. The photo shows the type of bit used to remove the original ...

2 years ago
Forum
Reply
RE: Question on initial steering head bearing install

Final thought. Verifying the steering bearing preload by riding. If the preload is too little (loose), going 30 to 40 mph in 3rd gear, loosen your g...

2 years ago
Reply
RE: Any active airhead owners near dallas texas area? I am new to this airhead community.

Hello Rana. I’m in Texas, but like 3 states away in the Rio Grande Valley. It is frustrating that you can not search the ABC Member Directory by State...

2 years ago
Reply
RE: Question on initial steering head bearing install

Oy, … I am confused by this discussion. My bike is a ‘78, but here the ‘88 looks very similar. There are 2 nuts at the top of the steering tube. One i...

2 years ago
Reply
RE: New member intro and questions

I am curious about “base of the cylinder sleeve is quite marred”. I do agree - as long as the mating cylinder to block mating surfaces are in good s...

2 years ago
Reply
RE: New member intro and questions

That damage is a real head scratcher. It must have occurred with the cylinder removed, to expose that surface. Is there a corresponding mark on the c...

2 years ago
Reply
RE: Ignition Issues with Aftermarket Systems

Another picture of the EME module mounted atop the voltage regulator. I should add, the EME system is also very reasonably priced!  IMG_0355...

2 years ago
Reply
RE: Ignition Issues with Aftermarket Systems

Hello again. I chimed in earlier in this saga. 1978 R100(RS). I’m still running with the EME / Sachse ignition system. Mine is the variation that fit...

2 years ago
Page 7 / 24

Advertisement

Scroll to top