W/ ref. to your above statement .... some may think that if LEDs are used it's ok to swap wires to smaller gage ...... hum hahah. It's a fact. L...

ATF or any one of the million WD-40 like thin oil penetrants.

It's worse than that. My wife bakes cakes professionally. Her support forum is warning pros not to make cakes with football team mascots, corporate or...

I love your ground cable attachment upgrade! That is pure genius. I have considered routing mine to one of the starter mounting bolts, ala automot...

What has been so eloquently contributed is great, but may be somewhat dated. Two points... ► First, I prefer to teach charging systems using the me...

The last time this happened to me the bolt holding the shift lever in place had simply come loose. 🙂

Thanks for the reply. I am a little confused by your reply though. You said that the majority of motorcycle use radial bearings, then say I might rec...

I looked on the Woody's web site and didn't see any mention of a bearing conversion. Two comments.... ► Although there are sealed tapered roller ...

I ended up buying a 60 inch starter cable (with 5/16 eyelets on each end) and cutting it in half, since 30 inches seemed to be the correct length. The...

They seem to use a low profile fitting on the brake pedal for safety, but that fitting can be removed with a 4mm socket. The hole can then easily be e...

Saw this morning where Chaparral Motor Sports has the Bridgestone S11 tires on sale, each seem to be roughly $10 off their already low prices. Chaparr...

Rear brake pedal pivot, and both swing arm bearings (under the round plastic caps)

Speak of the devil and he appears... While test riding my buddy's 1975 R75/6, I stopped to take a picture in front of a post office about 90 minute...

I'm using a Boyer which has performed flawlessly, except for one time on each trip the ignition quits. I've learned that the CPU in the digital Boyer ...

I ended up rebuilding the switch myself and it works great now.