And please put your general location in your profile so that other members can help you. Has someone looked at the bike to make sure it's safe to ...

Greg - I'll do everything I can to help you, but obviously the "teach by wire", however good it might be for disease prevention, precludes a LOT of t...

Welcome Aboard ! Hi Greg ! ► There is a key position provided for emergency parking in which the ignition is OFF, but the tail lamp is ON. That ...

Let's get back to the OP's issue.

This topic is thoroughly covered HERE

Yes, like Scot said. A special axle with inward facing cones is used to "chuck up" the wheel. Then when everything is tight, that axle sets on 2 new b...

Can't recommend a mechanic, but I can recommend a good shipper.... I recently sold a bike into NJ and the new owner wanted to ride it home, but becaus...

A complete engine should be available. They made thousands of these things and they were extremely popular in the day. And you'll end up with lots of ...

Thanks will do. When u get going its perfectly normal. Its really hard to detect but something does not feel right. There are many issues, that, when...

It could be any part of the drive train, from the gearbox out to the rear wheel bearings. I'd start by peeling the swing arm boot back and then runnin...

Welcome Aboard ! You didn't say how many miles, but these engine typically go 250,000 easily. If your mileage is less than that, then the crank is ...

Sorry to hear that. My shop is always open. Ride 1500 miles due South, and take a Left when you get to Atlanta ! 😛

Would really like to know the end of this story !

Yes, you can't ignore the reservoir level while you're bleeding. An important lesson that's been self-taught to thousands of Airhead owners !! :lol...

Welcome Aboard ! You won't need to be a licensed jet engine mechanic or a degreed engineer to get one of these bikes running their best in a very s...