I purchased a set of the Biltwell Renegade’s, 7/8”. Installed them today. Clutch side was very typical. Throttle side was quite challenging! Took som...

Don’t want to “hijack” this thread, but, this got me thinking about my sorry old grips. My bike is a ‘78 R100. What is the correct grip size? Is it ...

Wow, never seen one of those. Is that supposed to draw heat up out of the oil? Is there a liquid inside that helps convey the heat? V..e..r..y inte...

Hello, Mark! From way down in south Texas. Good luck setting up your shop.

@13780 well, I found it; “The Cat” (being referred to here) is a high speed ferry that operates between Nova Scotia and Maine.

@16813 ok, I’m curious, what is “the cat”?

@edward-silverman hello Edward. I’d start a new forum topic with your question. Folks may not see it here.

I’m planning on attending the “Hill Country Hangout” in Kerrville, TX (just NW of San Antonio) on April 19 & 20. It’s an MOA sanctioned rally put ...

@16813 hello, Mike

I’m 68 these days. The airhead I ride I bought when I was 25. I don’t think I could part with it. We have covered a lot of miles together, and venture...

This thread by Eric is titled “1978 R100RS … “

‘78 RS also. My BMW service manual says 72 - 76 ftlb.

Crazy good job on the “jig”. I’m gonna use that design, if you don’t mind! A tool I’ve found handy for fork tops and bottoms is a wrench like this (...

I bought the EZ return springs. Had them on for a while, then went back to standard springs. Maybe I didn’t give myself enough time to adjust, but, wi...

I’ve been using the Cyclops LED for several years. I, also, do not ride at night typically. The few times I have, I’ve thought the light was quite go...