Also consider that... ► The kit only includes pistons and cylinders. The valves and carbs will remain at the smaller size (smaller than an R100) whi...

Actually the cable in question is a perfect fit on the lower bolt holding the Ignition Control Unit. I unwrapped some of the cable and sure enough th...

The 12 volts read on the multi-meter whether the ignition is on or off. I am using the motor block as the ground. Then I suspect it is as Bob has...

OK, great! You say there's 12V between this wire and "ground" with your meter, but you did not specify with the ignition switch in the ON or OFF po...

Your correct. In engineering the saying is that most all adhesives have fairly restrictive useful temperature zone. Ones that are good for cold enviro...

I rechecked all the electrical connections and the only questionable connection I made was to ground the wire that is prominent in the first pic. I d...

I'm new on this board - so please forgive me if I'm making a protocol or procedure error in replying here. (And please advise me how to do it properly...

Very clean job of it. I like !! You'll love the stainless brake lines. However, that funny loop over the front fender will entrap air and keep the ...

Guess Wobbly missed it? 🙂 Yet another "Beginner Error". 😛

I looked in the manual and saw 0.10 and immediately went for the .010 feeler gauge, made the same mistake with the exhaust valve. I have the valves se...

A little follow-up for those who'd like some background... Asked my boss about this, because I was absent from the motorcycle scene (busy earning m...

Never mind Simply an observation, but IMHO someone who cannot wait for 2 days and 5 hours for a reply ought not to open the speedometer housing at ...

Look up the other thread here dealing with speedometers and odometers. The noise is caused by the oxidized lubricant refusing to flow any longer. Y...

A friend has told me that on his particular bike, it was the connector joining the hall effect board, not the electronic components themselves. He cut...

There's a reason AT&T makes more money than ladies with crystal balls. Asking is always better than guessing. I'd call Bob's and ask what they wer...