
Last seen: 04/18/2023 11:54
Screw is brass. I'd try to center punch and then drill from head side. Screw might come out. If the back side has not been deformed PO may have Lockti...
Correct compression? Rocker shaft end float?
Welcome. After fluids and filter change, I would try to crank. Check timing, brakes then look for any thing obvious and try a short ride. Unless the...
NAPA sells ML 1 for distributor cams. Same application. Bob
Welcome. Airheads being "Simple by choice" make a good project. Parts are available and there is a lot of informatioñ on line. Check on local tech day...
Anybody seen any money from Conty?
John Did you get a letter? I would of had Avons also, but couldn't find them when I bought.
Bing sells kits, 1-7 with 7 being the most complete: 2 floats, pivot pin, float needles, jet needles, needle jets, diaphragms, gaskets and o rings. Ca...
What does it take at this point? Four more bolts and lift out gearbox. Check for RMS leak, clean inside of disk splines as well as better clean input ...
Don't even think about mentioning that around the tag office. The paper says 72 it is a 72, write your check, get your tag and leave today. Questionin...
Wild A Guess-torque of engine mounting bolts. I don't have spec on anything that new.
I just did this with old tires-lots of tread, but too old. I went down once with a good looking tire which was maybe 6 years old and should not have t...
Is there a new editor?